Places on the head where the surface changes are ___ .
Reference points are used to establish _____ _____ .
______ _____ can be found by placing a comb flat on the side of the head/crest.
This bone protrudes at the base of the skull.
The highest point on the head is the _____ and can be found by placing a comb on the top of the head.
The ____ _____ signal a change in the shape of the head.
Bang or Fringe
Section that begins at the apex and ends at the front corners (represent the widest point).
Hair that grows at the crest hangs because of ______ .
Bang or Fringe
triangular section that begins at the apex, or high point of the head, and ends at the front corners.
The back side of the neck
area of the head between the apex and back of the parietal ridge.
______ lines that are perpendicular to the floor.
The space between 2 lines that intersect are ______.
These lines remove weight
These lines are parallel to the floor
A thin continuous mark
Lines that create fullness and blend long into short
Lines that build weight
Creates strong foundations and consistency in a cut.
To control the hair during a cut, then hair must be divided into _____ .
_____ is created by elevation and is described in ______.
When the hair is elevated less than ______ you build weight.
Elevation occurs when you lift any section above ___ .
A movable guide is a ______ guide.
The section that determines the length is the _____ _____.
This guide doesn't move.
This guide is used in a blunt cut and overdirection.
This is used in layered cuts to create a length increase in the design.
Back of the ear
To create longer layers toward the front, over direct the guide to the ___ ___ ____ ____ .
This is a conversation between you and the client.
The diameter of each strand is _____ .
The direction in which the hair grows
The amount of movement in the hair strands is _____ .
The amount of hair on 1 inch of head is called ____ .
Which shears remove more hair and have teeth farther apart?
What comb is used for short taper cuts?
A 6-8 inch comb with both fine and wide teeth used for cutting is called the ___ ___ .
With a cutting comb the wide teeth are used for ___ and the fine teeth are used for ____ .
The amount of pressure applied when combing.
Curly hair needs ___ tension.
Directly in front of cut
Where should you be standing when cutting?
Cuttin over fingers
The position of your hands when cutting a uniform
Palm to Palm
Position of hands when cutting vertically or diagonally.
Palm in shears
What reduces strain on index fingers and thumb.
After cut / before blow dry
When do we sweep up hair?
45 degree cut
cut that has less weight
One length cut
Long Layered cut
Cut at 180 degrees
How do we "check" a hair cut?
Avoid on curly hair as it creates frizz
This is a way to layer long hair without losing length.
this is performed on ends using the tips of the shears
What removes bulk without shortening?
Aggressive point cuttin
reduces volume and creates movement.
When ___ never completely close the scissors.
Which tool cuts hair by two moving blades?
Clipper over comb
This technique allows you to cut hair close to the scalp and create a flat top.