Upgrade to remove ads
Terms in this set (40)
when the original grade and the finish grade appear on the same site plan, the original grade is shown as ___ lines
the marker that is used to identify a known elevation on a particular plot is called a(n) ____
when the property lie is a curve rather than a straight line, it is identifies by a(n)
radius, length, and angle of tagency
the locations of utilities and buildings can be found on the ___
the proposed residence on a site plan is surrounded by contour lines that increase as they move away from the building. This indicated that the ____
building sits in a valley
bearings are expressed in ____
degrees, minutes, and seconds
a site plan shows the location of the building on the lot?
bearing indicated he direction of a property line?
if contour lines on a site plan are close together it indicated a gradual slope?
contour lines show the expected, finished grade of a site as short, dashed lines?
the topographic features shown on a site plan are comprised solely of natural objects?
plan north is the same as true north?
a building plot or piece of property is defined by lines called ___
instead of using short, dashed lines to show original grade, you can use ___ lines instead
on a site plan, underground pipes and cables are shown as ___ lines
the type of electrical plan that illustrates ceiling-mounted light fixtures is the ___
reflected ceiling plan
if you need to identify where a section has been taken from a plan or elevation, you must locate the ___
section cutting plane
when a large-scale illustration of a small portion of a building is required, you should consult a(n) ___ drawing
information on specification requirements for roof systems, floor framing, ceiling layouts, and walls can be found on the ___
to identify what type of door is being used in a floor plan, you should refer to its corresponding ___ in the door schedule
on what type of plan would you find existing walls and doors that need to be removes
in a set of drawings, architectural drawings are typically prefixed with the letter D?
exterior elevations indicate building materials such as siding?
details are made at a smaller scale than a plan drawing?
a door schedule typically includes the room number where the door is to be installed?
elevations that show the vertical surfaces of features such as cabinets are called ___ elevations
the specs for the final treatments required for floors, walls, and ceilings in each room can be located on the ___
room finish schedule
to find a list of materials of products required in a structure, you would consult a(n) ___
grade beams, caissons, and steel h-piles are all types of ___
auger cast piles are topped with a(n) ___to make the cluster work as a total load system
a concrete slab poured at ground level is called a ___
foundation walls and footings are shown as ___ in elevation views
a reinforced concrete beam that spans from footing to footing is called an auger cast pile?
a caisson has steel reinforcing cage installed before concrete is poured?
concrete block is an efficient way of constructing a foundation wall because no forms are required?
a(n) ___ may be cast in a footing if the footing will be used to anchor a poured, concrete wall
when the slab and footings are cast as one continuous unit, it is called a(n) ___
to prevent a slab from cracking, you should place a(n) ___ between the slab and the foundation walls
a (an) ____ is a linear section of PVC located in the concrete to serve as a moisture barrier
foundation walls do not allow water to pass through?
THIS SET IS OFTEN IN FOLDERS WITH...
Unit 7 TYK
Unit 6: Divisions "Print Reading for Construction:…
CM 1102: Print Reading for Construction
COSC 175 - Test 1 (Jackson Material)
YOU MIGHT ALSO LIKE...
Architectural Design - Fall 2016 Semester Exam Rev…
Chapter 8: Site Plans
Midterm Architectural Drawing
OTHER SETS BY THIS CREATOR
Safety Exam 2
MEP Exam 2
Law 1 Exam
ARCH Exam 5