Only $2.99/month

Terms in this set (781)

To view port information, such as port type, speed, duplex settings, or statistics and errors, use the show interface interface-id privileged EXEC command. The following command shows the information for interface g0/1. You should be familiar with the highlighted areas.
vc-core#show interface g0/1
GigabitEthernet0/1 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet Port, address is 000d.65ac.5040 (bia 000d.65ac.5040)
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, link type is auto, media type is 1000BaseSX
input flow-control is on, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:09, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 10000 bits/sec, 8 packets/sec
5 minute output rate 10000 bits/sec, 7 packets/sec
1476671 packets input, 363178961 bytes, 0 no buffer
Received 20320 broadcasts (12683 multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
1680749 packets output, 880704302 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out