Upgrade to remove ads
Source: Air Drone Craze - http://www.airdronecraze.com/quick-reference-guide-of-drone-terminology/
Terms in this set (82)
A consistent circular turn in either the clockwise or counterclockwise direction
Staying in the same position while airborne. Done by controlling the throttle
Flying in a "figure 8" pattern
If you were looking down on a drone from above, yaw refers to the movement of the drone clockwise or counterclockwise
Simply describes movement up and down along the vertical axis from the front to the back of the drone
2.4 Ghz Spread Spectrum
Ghz is short for gigahertz and describes the radio frequency rate used by a drone controller. The 2.4 gigahertz spread spectrum controllers have become the gold standard for drone RCs. Because the spread spectrum is "frequency agile," it can "hop" to different frequencies to account for any atmospheric or other issues a drone pilot may experience, which means fewer crashes.
This is a common term for a range of very small cameras, which are often sold as keychain cameras. They are extremely lightweight and are used by hobbyists in order to take pictures from a multi-rotor aircraft.
A device that measures the acceleration forces in a certain direction and helpful in maintaining the Drones orientation. These devices are used to stabilize quadcoptors.
the hobby of capturing images and video while in the air with a camera mounted to your drone.
Altitude above ground level
Altitude Hold function
Allows pilot to focus on the camera while the drone hovers steadily in air by itself at a set height. A Onboard barometer is needed to allow Altitude Hold.
Almost ready to fly. This is used to describe a Quadcopter or a Drone that you are purchasing and what comes with it. ARF units will many times come without the transmitter, and they may require some assembly.
A capability of a drone to conduct a flight without real-time human control. For example, following pre-set GPS coordinates.
There are some SUAVs's that are managed by internal programming that have instructions on where to fly as guided by an onboard GPS system. This is in opposition to steering mechanisms that are operated by radio control from the ground.
One plane of potential flight. Most quadcopters have at least 4 axis controls, with 6+ being preferred.
Balanced Battery Charger
This is a charger or an internal system for Lipo batteries (or different chemistries) which uses smart technology to charge multiple cells properly that are located within the battery and balances them.
Barometric Pressure Sensor
This device used barometric readings to determine the altitude of the aircraft. It can help drones to be able to calculate their height above the ground, along with using combinations of other sensors. ( Enables Altitude Hold feature )
This is the process of making the controller (Transmitter) communicate with the quadcopter or the drone.
Bind N Fly. The unit is ready to bind to your transmitter and fly.
These motors have permanent magnets that rotate around a fixed armature, which eliminates any problems that could be associated with connecting current regarding a moving part. The brushless motors are much more efficient and hardy than brushed motors.
A unit that is build at home as opposed to one that is store bought.
Beyond visual line of sight.
This is actually the holder of the camera used on drones. It can tilt and swerve, thanks to the servos that power it. The gimbal is strong enough to support even large DSLR cameras.
flying a drone for money-making purposes. This is currently restricted by FAA regulations unless you apply for and receive an exemption.
The handheld device that is used by the drone pilot that is used to control the drone and the quadcopter. Controllers are also called transmitters. Here is a picture of a higher end controller.
UAV capable of autonomous flight
Electronic Speed Control
ESC. The device for controlling an electric aircraft's motor. It is the connection between the RC receiver and main battery. It usually includes a Battery Elimination Circuit (BEC), which provides the power for the onboard electronics like an autopilot and the RC system.
Federal Aviation Administration A United States Department of Transportation Agency, with the authority to regulate and oversee all aspects of American civil aviation.
First Person View
Also known as FPV, a system in which the drone operator views the camera footage from the drone in real-time. The video stream is either viewed through a pair of special goggles, or to a device like a tablet or smartphone.
The sketch or software loaded into the microprocessor based products' non-volatile memory. The reason it is referred to as firmware is because it remains in non-volatile memory state even when power is removed. Therefore, it is non-volatile. In the autopilots case, it is an application (App for smart phone users) or program that determines how and what the auto pilot does
Acronym for "First Person View." This is also known as "Remote Person View" (RPV). The FPV is situated on a camera (such as GoPro) and is mounted on the Quadcoptor which allows the operator view exactly what the aerial vehicle is viewing in real time.
Flight Control System
This is a network of controls that is interconnected and allows the pilot to fly the quadcopter or any other multi-rotor airborne vehicle.
Unintended flight outside of operational boundaries (altitude/airspeed/lateral) as the result of a failure of the control element or onboard systems, or both.
Fly-Away Protection System
A system that will return the UAV safely to the surface, or keep it within the intended operational area, when the link between the pilot and the UAV is lost.
This is a specialized mount for a camera, giving it the ability to swerve and tilt by utilizing servos. This gives the camera the capability of staying in one position, regardless of the movement of the drone. This allows for a very smooth and stabilized and smooth looking image.
Top name in high-definition camcorders, often used in extreme-action video photography. It is an HD-quality, waterproof video recording device that is compact, lightweight, rugged. With attachments they can be wearable or mounted on vehicles.
Global Positioning System that is used to track the position of an object in relation to the global spatial plane, track movement, or cause an airborne vehicle such as a quadcoptor to hold position, such as the advanced Dji Phantom.
Ground Control Station
GCS. This software runs on the ground on a computer. It receives telemetry information via an airborne UAV. It displays its status and progress. This frequently include sensor and video data. It also can be used for transmitting in-flight commands up to the UAV in the air.
A gyroscope or gyro, measures the rate of rotation of the UAV and helps keep the craft balanced correctly with respect to yaw, pitch and roll. Helps to maintain the orientation of the quadcopter while in flight. In most cases, quadcopters use a triple-axis gyroscope.
A multi-rotor aircraft having six rotors in which the beauty and advantage of the hexicopter is that it can lose any single engine and still maintain control to land.
Better than toy grade, these quads can offer a good reliability and operation at a reasonable price tag. The Syma X8G, JJRC H25G and Parrot AR.Drone 2.0 are a few examples of hobby grade quads.
regardless of the orientation of the craft, the way the front of the craft is pointed, it will follow your stick movements.
The Inertial Measurement Unit is a controller which combines an accelerometer and a gyro, with the purpose of helping with the orientation and stabilization of a quad.
Inertial Navigation System
INS. This is a means of calculating position that is based on the initial GPS reading. This is followed by speed and motion sensor readings that use dead reckoning. This is useful when the GPS has lots its signal temporarily or is not available.
intelligent orientation control - Usually, the forward direction of a flying multi-rotor is the same as the nose direction. By using Intelligent Orientation Control (IOC), wherever the nose points,the forward direction has nothing to do with nose direction
Line of Sight
Also known as LOS, refers to being able to see your drone from your operating position with your naked eye. Your drone should always be within your line of sight.
Short for Lithium Polymer, LiPo is the type of battery favored by most drone manufacturers due to its low weight and maximized charge capacity and power. Although LiPos are safe, be aware overcharging the battery or breaking the flexible polymer case could result in fire.
Lithium Polymer battery
LiPo or LiPoly. The Lithium Ion battery (Li Ion) is a variant. Lighter weight and more power is offered by this battery chemistry compared to NiCad and NiMh batteries.
Popular lightweight camera model which can shoot video in HD and take intervalometer photos. It was developed mainly to be used with RC drones.
modification: Drone addicts modify their machines to integrate new functions or cool features. These changes are usually called mods.
A generic name for a drone with multiple propellers. Aerial drone with multiple horizontal propellers, also known as rotors. Depending on the number of rotors, we can have tricopters, quadcopters, hexacopters, octocopters and so on.
are referred to by many names, which include: Drone, Quadcopter, Quadricopter or Quadrocopter
is a flight controller that is used on the DJI Phantom Drones and it does the main control chip, an accelerometer, a gyroscope, and a barometric altimeter.
No Fly Zone
Areas where flying a drone is restricted by government regulations. Areas where a drone could interfere with an airplane or record sensitive information make up most of these areas.
A drone with 8 horizontal propellers or rotors.
A term that stands for On Screen Display.
The amount of additional weight a drone is able to lift in addition to its own weight and batteries. If you attach a camera and gimbal to your drone, the combined weight is the payload.
A measure which describes the flight angle along one axis, usually measured from level in case of aerial vehicles.
Pre Flight Planning
The activities conducted by the pilot and flight crew prior to takeoff to ensure that the flight will be conducted safely and in accordance with all applicable standards and regulations. The activity includes, but is not limited to, such things as checking weather, route of flight, airspace, equipment configuration, support personnel, terrain and communications requirements.
Power Distribution Board
is the PDB and is a board that is used on the multicopters to help distribute the power to each of the motors to provide proper stabilization of the unit.
UAV that typically has 4 propellers, situated in a square formation for smooth and precise flight.
wireless handheld device used to control flight of the drone.
Synonym for Radio Controlled.
Shorter way of writing "Radio Controlled - it refers to control of a drone via radio waves.
Ready to Fly - This means the drone is sold with everything needed in the pack. All you need to do is put it together, add batteries and you are ready to use it. It is possible you may need to buy the batteries separately. This fact is usually mentioned on the box.
Sense And Avoid
The capability of a UAS to remain well clear from and avoid collisions with other airborne traffic. Sense and Avoid provides the functions of self-separation and collision avoidance.
A shorter name for servomotor or servomechanism. Aerial vehicles use servomotors for various functions such as pan cameras and wing flaps adjustments which can be controlled from the ground.
is short for - small Unmanned Aircraft System
Control that influences the RPM or the speed of electric motors.
The basic level of quadcopters, usually priced under $100, using relatively cheap components. Not very reliable, toy grade quads can still offer a wide variety of functions. They can be an excellent way to start for beginners, as they can still provide a lot of fun, despite the lack of reliability. when you are ready, you can move on to a hobby grade machine or even or more advanced ones, but you have to be ready to pay a higher price.
Short for transmitter or transmit
unmanned aerial vehicle. A device that can propel itself through the air without a pilot onboard. Drones and quadcopters are UAVs.
A sensor that uses the ultra sound wavelength to communicate with a transmitter. In aerial vehicles, ultrasonic sensors are used for calculating the distance to the ground by bouncing sound waves back and forth. They don't work further than a few meters from the ground.
Visual line of sight
is the term that is going to control how the pilot can see the aircraft from the ground without the use of artificial vision.
A crew member who assists the UAS pilot in the duties associated with collision avoidance. This includes, but is not limited to, avoidance of other traffic, airborne objects, clouds, obstructions, and terrain. Most associated with FPV flying.
Abbreviation for Visual Line of Sight.
A set of coordinates which define a point in space. Waypoints are useful in designing various autonomous missions for quadcopters. Mapping out would be impossible without a possibility to define these physical locations.
The describes the quadcopter rotation around it's center axis on a level plane.
The most popular name for Small UAVs, which has 4 rotors positioned on a horizontal plane like a helicopter. Other names include Quadricopter, Quadrocopter
A generic name for a drone with multiple propellers. This covers quadcopters, octocopters, etc.
A multi-rotor aircraft having six rotors in which the beauty and advantage of the hexicopter is that it can lose any single engine and still maintain control to land
Has eight blades
THIS SET IS OFTEN IN FOLDERS WITH...
Drone Certification Abbreviations & Acronyms
Pilot Ground School Glossary of Terms
Certified Professional Photographer
YOU MIGHT ALSO LIKE...
Spirit A320- System Quiz's
Combo with "as220 final exam review (1-3)" and 2 o…
Terms and Definitions - Drones