Upgrade to remove ads
Carpentry 1- Roofing
Terms in this set (39)
A gable end roof member that extends beyond the gable to support a decorative end piece. AKA-Fly Rafter
the lower member of a truss
frame work extended from the roof surface that provides additional light and ventilation to an attic
the board that is attached to the tails of the rafters to straighten and space rafters to provide a nailing surface for fascias
triangular wall enclosed by sloping ends of a rigid roof
a roof with 4 sides or slopes extending toward the center
structural member used to frame an overhang
Open Web Steel Joist
steel joist AKA bar joist used to support roof loads
a horizontal roof support member parallel to the plate and installed between a plate and ridgeboard
a 1x4 nailed to the ceiling joist at the center of the span to prevent twisting and bowing of a joist
Horizontal board placed at the ridge of a roof
rigging device used when lifting large members with a crane
a framing method in framing members are installed at one time
an L-shaped arrangement of lumber used to support ceiling joist
cord/rope attached to structural member to assist in guiding members into the proper position
metal anchoring device used to fasten members to one another
the amount in inches that a common rafter will rise
_________ __________ keep opposite walls of a structure from spreading apart
To transfer roof loads to the foundation, ceiling joists are usually installed directly over ________ __________
When ceiling joist are overlapped above a load bearing partition, the overlap must be at least ____ inches
A shed dormer is typically used in ________ ________ style.
A board nailed to the tails of rafters to provide a nailing surface for the fascia is ______ _______
The type of cut made to a rafter so it will rest squarely on the top of the top plate is a _______ _______
The distance between the last two rafters cannot be more than __________ inches
In order to have the correct rafter length for a common rafter, you must subtract __________ the ___________ of the ridgeboard
A bird mouth cut on a rafter should not exceed ______ the width of the rafter.
Local fire codes must be consulted when framing around a chimney to establish
When collar ties are needed to brace rafters, they are installed on every __________ rafter
The _______ cut on a rafter is toe-nailed to the ridge board.
The common difference measurement is used to determine the lengths of _____________ studs.
A _______ _______ is used to allow heat and moisture to escape the building.
The vent opening in a gable end is framed using a header, a sill, and _________ studs
When used with masonry or concrete walls, bar joist are welded to _______ embedded in the walls.
A _______ ________ is needed to lift trusses if the span exceeds 40'
If trusses or rafters are installed 24" OC, use _________ inch sheathing
A _______ inch space must be left between roof sheathing to allow for expansion
To eliminate the need for tongue and groove sheathing, connect adjoining panels with _______ clips between rafters and trusses
When compared to common rafters, barge rafters are typically one ________ narrower.
When compared to rafters, ridge boards are typically one _________ wider.
THIS SET IS OFTEN IN FOLDERS WITH...
Carpentry - Roof Framing
Carpentry subset: Structures/Components
Ontario Building Code
Carpentry-Chp 8 Intro to Concrete & Reinforcing ma…
YOU MIGHT ALSO LIKE...
Module 7 Ceiling and Roof Framing
Module 7 Ceiling and Roof Framing
Module 7: Ceiling and Roof Framing Trade Terms
MODULE 7 Trade Terms CEILING JOIST & ROOF FRAMING
OTHER SETS BY THIS CREATOR
Level 1 Carpentry Final Exam
Carpentry Theory 1
Carpentry Test 1
Carpentry 1- Building Envelopes