Upgrade to remove ads
Only $2.99/month

CCNA 2 R&S Essentials Chapter 6 QUIZ

Pearson_IT
Get Quizlet's official CCNA - 1 term, 1 practice question, 1 full practice test
Preview

Terms in this set (15)

On R1, the command to configure a static route to network 172.16.2.0 by specifying the next-hop IP address is ip route 172.16.2.0 255.255.255.0 "_________________ ".
192.168.2.2
What is a supernet?
summarization of serveral IP classful networks into one IP address range
What type of static route is created when the next-hop IP address and exit interface are specified?
fully specified static route
A "______" network is a network that is accessed by a single route.
Stub
Which option shows a correctly configured IPv4 default static route?
ip route 0.0.0.0 0.0.0.0 S0/0/0
Refer to the exhibit. Which set of commands will configure static routes that will allow the Park and the Alta routers to a) forward packets to each LAN and b) direct all other traffic to the Internet?
Park(config)# ip route 0.0.0.0 0.0.0.0 192.168.14.1
Alta(config)# ip route 10.0.234.0 255.255.255.0 192.168.14.2
Alta(config)# ip route 0.0.0.0 0.0.0.0 s0/0/0
Which two statements describe static routes? (Choose two.)
They require manual reconfiguration to accommodate network changes.*

They are identified in the routing table with the prefix S.*
Fill in the blank.
A "_______________" static route can be used to provide a backup route to a dynamically learned route.
floating
Which two conditions must exist in order to summarize IPv6 routes into a single static IPv6 route? (Choose two.)
The destination networks are contiguous and can be summarized into a single network address.*

The multiple static routes all use the same exit-interface or next-hop IPv6 address.*
Which is a valid summary route for networks 192.168.8.0/22, 192.168.12.0/22, and 192.168.16.0/22?
192.168.0.0/19
Perform the tasks in the activity instructions and then answer the question or complete the task.

Why are the pings from PC0 to Server0 not successful?
The static route to network 192.168.2.0 is misconfigured on Router1.
What command, or set of commands, would be used to determine if the following configuration on router HQ works as designed?

ip route 0.0.0.0 0.0.0.0 serial 0/0/0 10
ip route 0.0.0.0 0.0.0.0 serial 0/1/0
HQ(config)# interface serial 0/1/0
HQ(config-if)# shutdown
HQ(config-if)# end
HQ# show ip route*
A network administrator enters the following command into Router1: ip route 192.168.0.0 255.255.255.0 S0/1/0. Router1 then receives a packet that is destined for 192.168.0.22/24. After finding the recently configured static route in the routing table, what does Router1 do next to process the packet?
encapsulates the packet into a frame for the WAN link and forwards the packet out the S0/1/0 interface*
Why would a summarized static route be configured on a router?
to reduce the size of the routing table
Which subnet mask would be used for a network that has a maximum of 300 devices?
255.255.254.0
YOU MIGHT ALSO LIKE...