Study sets, textbooks, questions
Upgrade to remove ads
Chapter 9 - Haircutting
Terms in this set (45)
The foundation of every haircut is considered to be:
What line is parallel to the horizon and create a feeling of maximum weight or stability?
The liens used in hair cutting that create the illusion of movement and excitement are called:
The surface feel of each hair strand determines what?
Cutting the hair at 0 degree projection creates the effect of a solid form or a:
What type of form would result from using a 45 degree projection or elevation angle?
Uniformly layered form
A layered cut or 90 degree cut is known as:
Circular shape, activated texture, and same shape throughout
What does a uniformly layered formed haircut look like?
What cutting implements is used to create a clean, blunt edge?
Regular alternation of short and long lengths
When cutting with a razor what is NOT achieved?
Which finger should be placed in the finger grip to control the still bland when holding the shears?
The movable blade of the shears is controlled by the:
Close your palm over the shears
To hold the comb and shears in the same hand without jeopardizing the client's safety, release the thumb grip and:
Taper shears, also known as thinning shears, are used on the end of the hair to:
When using electric clippers, the attachment that allows the hair to be cut to one exact length is the:
Outline and refine the hairline
A trimmer, also known as an edger, is a tool used to:
From side to side
As it cuts hair the movable blade of the clippers moves:
Which tool controls short perimeter length when cutting against the skin?
The area all around the hairline is referred to as the:
The apex refers to what part of the head?
The term used to describe dividing the head into workable areas for the purpose of control is called:
The most natural looking result of the line is achieved when cutting the hair in which of the following head positions?
Which head position hen cutting hair results in an inclination or a slight graduated effect?
What type of distribution results in a 90 degree angle from its parting?
What term, also known as elevation, is the angle at which the hair is held in relation to the curve of the head prior to cutting?
0 to 30 degrees
What angle best represents low projection (elevation)?
Projecting the hair below 90 degrees would
What line is considered to be the artistic guideline while cutting hair?
A stationary design line is a guide to where all lengths are directed and is:
Concentration of lengths
A weight area in a graduated form could be described as a:
What term identifies the technique used to check the accuracy of a haircut by using the opposite parting pattern?
A design line that is used as a length guide for cutting graduated, layered and square forms is referred to as:
Cutting shorter lengths within the form to reduce bulk and create support and mobility is called:
Shortening and overall length appearance of the hair
Texturizing reduces bulk without
A technique performed on the ends of the hair to reduce bulk, allow for mobility, soften the ends and blend weight lines is called:
To maintain control of the hair, what hair type should be texturized the greater distance from the scalp?
To allow for more control and the shrinkage factor, very curly hair should be texturized while it is:
Anywhere around the hairline
Allow additional length in the growth pattern area
To accommodate a growth pattern such as a widow's peak, cowlick or whorl when cutting the hair, what would apply?
What growth pattern forms from a point at the front hairline and curves to one side?
Density of the hair
When performing a haircut, what determines the size of a parting?
Before performing a blow dry service
Infection control procedures include sweeping and disposing of cut hair:
Conversion layering is a common cutting technique used to create:
The higher the projection or elevation angle, the steeper the line of:
Partly wet and partly dry
An uneven effect is created when cutting curly hair that is:
Sets with similar terms
Chapter 9- Haircutting
Chapter 9 Sculpture
Chapter 9 - Haircutting
Sets found in the same folder
Chapter 10 - Hairstyling
Chapter 12 - Chemical Texturizing
Laws: 1st part
Other sets by this creator
Chapter 13 - Haircoloring
Chapter 11 - Wigs and Hair Additions
Chapter 8 - Design Decisions
Chapter 7 - Trichology
Other Quizlet sets
FinAcc - Chapter 14 ( Corporations: Basic Consider…
OB 2&3 trimester part 3
chapter1 unit1 focus
9. Is a form of constructed sculpture in which preexisting, or found objects recognizable in form are integrated by the sculpture into novel combinations that take on a life and meaning of their own
The term 'contrapposto' is exemplified by
in architecture, decorative masonry made by cutting back the edge of stones
Venus of Willendorf, Venus of Brassempouy