JWinn73 - Walk-Around

The Forward Entry Door is not fully latched until the handle is _____
Click the card to flip 👆
1 / 64
Terms in this set (64)
The Forward Entry Door is not fully latched until the handle is _____
• Below the 3 o'clock position

[Spank]
The Overwing Exit Door Handle Covers should be installed with the _____
• Indented area facing down

[Spank]
The Overwing Exit Door Handle Strap is located in the _____
• Forward corner of the aft door

[Spank]
The Red Indicator on the Emergency Flashlights should be _____
• Blinking (extinguished means no power)

[Spank]
On the -800 aircraft there are _____ Rafts located in the _____
• Three
• Cabin center ceiling

[Spank]
The EEMK is equipped with a lock and the key is kept by the Flight Attendants in a _____
• Pouch inside a large red binder

[Spank]
The three on-board Wrist Restraints are located in a pouch behind the _____
• EEMK

[Spank]
N: Assessing the condition of the Upper Wing Surfaces may
require _____
• Viewing from inside the aircraft

[NP.20.4]
During the Exterior Inspection, ensure Installed Placards are _____
• Readable

[NP.20.4]
During the Exterior Inspection, ensure Gear Struts are _____
• Not fully compressed

[NP.20.4]
During the Exterior Inspection, ensure that Probes, Sensors, Ports, Vents and Drains are _____, _____ and _____• Unobstructed • Clear • Undamaged [NP.20.4]During the Exterior Inspection, ensure that the skin area adjacent to the Pitot Probes and Static Ports is not _____• Wrinkled [NP.20.4]During the Exterior Inspection, ensure Light Lenses are _____ and _____• Clean • Undamaged [NP.20.4]During the Exterior Inspection, notify Mx if a tire has: • Any tread groove _____ • A layer of _____ • A questionable _____ • Any appearance of _____ • Any missing or damaged _____• Worn away completely around the tire, • Cord showing, • Cut, • Improper inflation, or • Through-Bolt or Nut [NP.20.4]During the Exterior Inspection, notify Mx if a tire is _____ or _____ if any Tread is _____• Worn beyond limits • Damaged • Separating [NP.20.4 and 5]During the Exterior Inspection, you should see a Ventral Strake on _____ aircraft• -900ER with SSW [NP.20.7]This is the _____• Aspirated Total Air Temperature Probe [Walk-Around Slides]This is the _____• Left Angle of Attack Vane [Walk-Around Slides]During the Exterior Inspection, the Windshield Wipers should be _____ and _____• Undamaged • Parked [Walk-Around Slides]These are _____ which are found on _____ aircraft and they should be _____• Windshield Vortex Generators • -700 and -900 • Secure [Walk-Around Slides]This Entry Door is _____• Soft Latched [Walk-Around Slides]These are _____ and they should be _____• Diverter Strips • Secure [NP.20.5]This is the Nose Gear Steering _____ with the _____ installed• Towing Lever • Steering Lockout Pin [Walk-Around Slides]During the Exterior Inspection, if the Towbar is attached the Towing Lever should be _____ with the _____• Set to Bypass • Steering Lockout Pin installed [NP.20.6]This is the _____ and the Cylinder should be _____ and _____• Nosewheel Steering Assembly • Visible • Not collapsed [Walk-Around Slides]This is the _____• Taxi Light [Walk-Around Slides]This is the Nosewheel _____ and it should be _____ and not _____• Spin Brake • Secure • Worn to the Attachment Screws [Walk-Around Slides]This is the Main Gear _____• Down-Lock [Walk-Around Slides]This is the Nose Gear _____ with the _____• Down-Lock • Pin installed [Walk-Around Slides]This is the First Officer's _____ and it should be _____• Emergency Exit Handle • Stowed [Walk-Around Slides]This is the Right _____• Angle of attack Vane [Walk-Around Slides]This is the _____ Switch• Nose Wheel Well Light [Walk-Around Slides]This is the Access Door for the _____• Forward and Aft E&E Compartments [Walk-Around Slides]This is the Right _____• Wing Illumination Light [Walk-Around Slides]These are the _____ and _____ Lights• Fixed Landing • Runway Turnoff [Walk-Around Slides]The Right Leading Edge Flaps may _____• Droop from the stowed position [Walk-Around Slides]This is the Right _____ and it should be clear with the Door _____ and Deflector _____• Pack Air Deflector Door • Opened • Extended [Walk-Around Slides]This is a _____ Light and it should be _____, _____ and _____• Retractable Landing • Undamaged • Extinguished • Retracted [Walk-Around Slides]This is a _____ and it should be _____• Vortex Generating Device (Strake) • Undamaged [Walk-Around Slides]These are _____ and they should be _____ and _____• Thrust Reverser Sleeves • Stowed • Aligned with the Center Fairing [Walk-Around Slides]This is a _____ and it should be _____• Temperature Probe • Undamaged [Walk-Around Slides]This is a _____ and it should be _____ and _____• Fuel Measuring Stick • Flush • Secure [Walk-Around Slides]During the Exterior Inspection, ensure the Leading Edge Slats are _____• Faired [Walk-Around Slides]This is a _____ and it should be _____• Vortelon • Secure [Walk-Around Slides]This is a _____ and it should be _____ There are _____ and _____ versions of this• Fuel Tank Vent • Unobstructed • Pressurized • Unpressurized [Walk-Around Slides]During the Exterior Inspection, ensure the Static Discharge Wicks are _____• Present [Walk-Around Slides]These are the _____ and _____• Flaps • Fairings [Walk-Around Slides]This is a _____ and it should be _____• Brake Wear Pin • ??? [Walk-Around Slides]This is an _____ and it should be _____• Impact Fitting • Intact [Walk-Around Slides]During the Exterior Inspection, ensure the Hydraulic Reservoirs are _____• Above Refill [Walk-Around Slides]During the Exterior Inspection, ensure the APU Remote Fire Panel _____• T-Handle is stowed [Walk-Around Slides]This is a _____ and it should be _____• Negative Pressure Relief Door • Undamaged [Walk-Around Slides]During the Exterior Inspection, ensure the Outflow Valve is _____ and _____• Undamaged • Open [Walk-Around Slides]This is a _____ and it should be _____• Positive Pressure Relief Valve • Undamaged [Walk-Around Slides]This is the _____ and it should be _____• APU Air Inlet and Deflector • Undamaged [Walk-Around Slides]This is the _____• Elevator Feel Pitot Probe [Walk-Around Slides]This is the _____ and it should be _____ and _____• White Strobe Light • Undamaged • Extinguished [Walk-Around Slides]This is the _____ and it should be _____• APU Cooling Inlet • Unobstructed [Walk-Around Slides]This is the _____ and it should be _____• APU Exhaust Outlet • Unobstructed [Walk-Around Slides]This is the Tailskid on the _____• -800 [Walk-Around Slides]There is no Tailskid on _____ aircraft• -700 [Walk-Around Slides]This is the Tailskid on the _____• -900 [Walk-Around Slides]This is the _____ and it should be _____• Water Drain Mast • Unobstructed [Walk-Around Slides]This is the _____ and the _____ and it should be _____ with _____• APU Fuel Shroud • Hydraulic Overflow Drain • Clear • No Fuel leaks -- Hydraulic Fluid is okay if from overfilling [Walk-Around Slides]