What is a BIT?
The smallest unit of information consisting of either a 1 or a zero. It can only represent two possibilities - either yes or no, black or white.
What is a color profile?
A mathematical translator assigned to each piece of equipment you use (they map one gamut to another; and the ICC (or International Color Consortium) profile is usually shipped by the equipment manufacturer).
What is gamut?
The entire range of colors that can be seen, reproduced, or captured. Our eyes have a greater gamut than a print or monitor.
How can you change the brightness of the background when using flash?
Change the shutter speed. The longer the shutter speed, the lighter the background will be. The faster the shutter speed, the darker the background will be because less existing light is captured.
What is interpolated resolution?
Interpolated resolution can be generated by Photoshop or any image editing software to increase print size resolution.
Why is depth of field greater on a short lens versus a long lens?
Relative aperture. The opening on a long lens must be larger than a corresponding opening on a short lens to produce the same f-stops.
What is focal length, technically?
The distance between the lens rear nodal point and the focal plane when the lens is focused at infinity.
A normal (or standard) focal length lens approximates what?
The impression of human visual perspective
What determines what will be a 'normal' focal length lens on a particular camera?
Sensor size - the larger the sensor size, the longer the focal length of a normal lens. (Corresponds to a diagonal line across the frame)
An in-camera reflected meter reading a very light toned scene indicates an exposure of 1/250th at f/8. For a correct exposure, what should you do?
Use positive exposure compensation (overexposure). A reflected meter reading will attempt to make the scene 18% gray - employ overexposure to adjust.
An incident-exposure reading for a fair-skinned subject reads f/8, 1/125th at 100 ISO. The next subject is very dark skinned. What is the proper exposure for the second subject?
No change. The EXPOSURE doesn't change or it would also change the background as well. Move the lights to adjust.
What is the general rule of thumb for the measurement of a 'normal' lens?
The diagonal measurement of the sensor.
What kind of light will be produced when using a large white umbrella close to a subject?
flat, low contrast light
What does a neutral density filter do?
Absorbs equal quantities of all wavelengths of light. It allows you to use wider apertures or slower shutter speeds without changing color balance.
Going clockwise around the color wheel, starting with RED, what is the progression of colors?
Red, Yellow, Green, Cyan, Blue, Magenta
What is a flag?
Also called a gobo; it is a small panel usually mounted on a stand that shades some part of the subject or shields the lens from light that could cause flare
A filter with a factor of 2 requires how many stops of compensation?
factor of 2 = 1 stop compensation. (Each time a factor doubles, it's one additional stop)
What is the name of the issue that prevents you from seeing exactly what the lens sees when using a rangefinder camera at close distances?
When buying a lens hood, you should get it in what size relative to the lens?
It should match the focal length. Too wide and it's inefficient; too narrow and it will vignette; most likely the vignette would occur with wide angle of 28mm and below.
A color image with smooth gradations requires at least what bit depth?
24 bits per pixel (8 per color), which gives 16,777,216 colors
In short lighting, where is the main light placed?
To strike the side of the face away from the camera.
What is a BYTE?
An 8-BIT sequence that represents 256 possibilities - black & white & 254 shades of grey. The size of a file is the number of bytes it contains.
Most lenses are sharpest closed down to how many stops from the widest?
1 or 2, depending on the lens, could be 2 to 3.
Name two ways you can increase depth of field (other than changing aperture)
1) Use a shorter focal length; 2) Move farther away from the subject
When the additive primaries are mixed together equally, what is created?
White (additive primaries are Red, Green Blue)
An in-camera reflected meter reading a very dark scene indicates an exposure of 1/250th at f/8. For a correct exposure, what should you do?
Use negative exposure compensation (underexpose). The meter will attempt to make the dark scene 18% grey, underexpose to bring it back to dark.
When the subtractive primaries are added together equally, what is created?
Black. Subtractive primaries are Magenta, Yellow, Cyan
What is the inverse square law?
The intensity of the illumination is inversely proportional to the square of the distance from light to subject. At twice the distance from the subject, the light illuminates only 1/4 of the original.
What is TTL?
Through the Lens. A camera that can automatically control flash exposure using sensors inside the camera.
If you must move to reduce the amount of flash reaching your subject, how far do you move?
To create a 1-stop difference, multiply the original distance by 1.4. Example - if you were originally 5 feet away, a 1-stop difference would have you step back to 7 feet.
What kind of lighting pattern is best for average oval faces and round faces you want to slim?
How much resolution do you need for: Internet? Newspaper? Photographic print? Glossy magazine?
Internet = 72 ppi; Photographic print = 240-300 ppi; Gloss magazine = 400 ppi
The useable exposure range of a sensor, or the range of subject brightness is called what?
dynamic range (not to be confused with gamut)
To emphasize texture in a portrait, what kind of light source is recommended?
Small light source at an angle brushing across the subject
What would you use an ICC profile for?
To set accurate color standards to any device that captures or displays color.
Generally, how much exposure compensation (in stops) should be used when using a polarizing filter?
1-1/2 to 2 stops
How would you define exposure in mathematical terms? (X times Y = exposure)
Intensity (aperture) x Time (shutter)
Name 3 ways to make a tonal adjustment in Photoshop
Curves adjustment; Levels adjustment; Brighteness/Contrast adjustment
What is burning?
Selectively increasing print exposure, which will make select parts of the image darker
What is dodging?
Decreases the exposure for areas of the print that the photographer wishes to be lighter
All objects beyond the closest distance in focus will be sharp when this appears within the DOF scale
What angle should a polarizing filter be to the sun for best results?
90 degrees. If using to eliminate reflections, it should be used at 35 degrees.
What does the term "stop" mean?
A change in exposure of 1 EV, that is 1/2 or 2x the amount of light.
The amount of motion blur in an image will increase if you do what?
lengthen (or slow) the shutter speed
What are the three main factors that affect depth of field?
Aperture, focal length, and distance to the subject
In the 20th century, black & white photographers used the Zone system to tame excessive contrast. Now, digital photographers use what?
High Dynamic Range
A ring of thin, overlapping leaves located inside the lens is called what?
The diaphragm - the mechanism that controls aperture.
What are quad- and hex- tone printing?
Inkjet black & white printing where color cartridges are replaced with shades of gray, resulting in smooth tones and slight color cast
What are luminance and illuminance?
Luminance is light reflected from the subject surface (measured by a reflected-light meter), while Illuminance is light falling on a subject surface (as measured with an incident light meter)
A lens with a very wide angle of view and produces extreme barrel distortion is what kind of lens?
This kind of meter is preferred by photographers working in a studio situation where lighting conditions can be altered
Incident light meter
This viewing option gives you the most accurate size version of your image in Photoshop
Actual Pixel view
In a 2:1 ratio, the shadow side of the subject would meter at X stop(s) less than the highlight side
One stop less
According to the Inverse Square Law, at a distance of 10 feet from a flash, the area illuminated receives how much more/less light than the area illuminated at 20 feet from the flash?
four times more
What kind of lighting pattern places the key light directly in front of and higher than the face?
What Photoshop tool allows you to select an area of any size or shape by drawing freehand?
When adjusting an image with levels, if you want to make any color neutral quickly, what would you do?
Click with the neutral-point dropper on the selected color
A histogram shows what in an image?
The brightness values of all the pixels in an image illustrated as a graph numbering from 0 to 255.
This stores electronic images captured in a digital camera until they can be transferred to a computer
Memory card / flash card / compact flash card
Using this kind of automatic exposure setting on the camera, you set the aperture and the camera sets the shutter speed
Using this kind of automatic exposure setting on the camera, you set the shutter speed and the camera sets the aperture
Doubling the aperture setting creates how many stops difference in the amount of light reaching the sensor?
A technique used to maintain sharp focus on a subject that is moving toward you is called what?
This type of file format compresses images by discarding pixels; therefore, each time an images is compressed, it loses pixels
In a digital image, the images file sizes corresponds to the total number of what in the image?
Total number of pixels
This type of data backup system is fault-tolerant because it creates and stores redundant data
According to the rule of thirds, where should the important parts of an image fall?
Along the lines of an imaginary grid at intersecting points that divide the image into thirds horizontally and vertically
The rule of thirds necessitates that the composition be divided into a grid of now many equal rectangles or squares?
What is the term used to describe human's change in perception of a color under different light sources?
If your print will be viewed mostly under window light, what is the suggested Kelvin temperature of the lights you should use to evaluate your print?
Most inkjet printers intended for photographic printing include light and dark inks of all of the colors except for one. Which color ink is usually available only in one density?
Whenever another image is copied or moved into a file, Photoshop automatically creates what?
A new layer
Instead of permanently altering your image when adjusting for color and value, what should you do?
Use and adjustment layer
To produce optimal sharpness, detail, and resolution, is a higher or lower ISO setting better?
If an image is too blue, what color adjustment should be made in Photoshop to correct it?
If an image is too magenta, what color adjustment should be made in Photoshop to correct it?
If an image is too yellow, what color adjustment should be made in Photoshop to correct it?
If an image is too green, what color adjustment should be made in Photoshop to correct it?
A histogram with peaks on either end of the histogram and a deep valley in between represents what?
A high contrast image
The histogram of a properly exposed grey card will show a vertical bar where on the histogram?
In the middle
True or false - a tonal correction can be accomplished by using a hue/saturation adjustment layer
Maximum depth of field at a given aperture is achieved by focusing at what?
Hyperfocal distance. A lens focused at the hyperfocal distance has depth of field extending from approximately half the hyperfocal distance to infinity, whereas a lens focused at infinity has a depth of field only at infinity.
If you're working with an automatic camera and you set the aperture and the camera sets the shutter speed, what mode are you working in?
If you're working with an automatic camera and you set the shutter speed and the camera sets the aperture, what mode are you working in?
What are the effects of lighting from above the subject's face?
Creates deep shadows in eye pockets, under nose, and chin.
What is the Aperture in a lens?
The size of the opening in the lens which controls the amount of light reaching the sensor.
As the aperture is stopped down, what happens to depth of field?
More of the background and foreground are sharp.