Study sets, textbooks, questions
Upgrade to remove ads
fcuk pass ur driving test nat
Terms in this set (19)
Open the bonnet, identify where you would check the engine oil level and tell me how you would check that the engine has sufficient oil.
Identify dipstick / oil level indicator, describe how to check oil level against the minimum and maximum markers.
Open the bonnet, identify where you would check the engine coolant level and tell me how you would check that the engine has the correct level.
Identify high and low level markings on header tank (where fitted) or radiator filler cap, and describe how to top up to correct level.
Open the bonnet, identify where the brake fluid reservoir is and tell me how you would check that you have a safe level of hydraulic brake fluid.
Identify brake fluid reservoir, check level against high and low markings.
Open the Bonnet, Identify where the windscreen washer reservoir is and tell me how you would check the windscreen washer level.
Identify windscreen washer reservoir and explain how to check level.
Tell me how you would check that the headlights & tail lights are working.
Operate headlights switch (turn on ignition if necessary) and walk around the vehicle.
Show me / explain how you would check that the power assisted steering is working before starting a journey.
If the steering becomes heavy the system may not be working properly. Before starting a journey two simple checks can be made. Gentle pressure on the steering wheel, maintained while the engine is started, should result in a slight but noticeable movement as the system begins to operate. Alternatively, turning the steering wheel just after moving off will give an immediate indication that the power assistance is functioning.
Show me how you would check the parking brake for excessive wear.
Apply footbrake firmly. Demonstrate by applying parking brake that when it is fully applied it secures itself, and is not at the end of the working travel.
Show me how you would check that the horn is working (off road only).
Check is carried out by using the horn control (turn on ignition if necessary).
Show me how you would check that the direction indicators are working.
Apply the hazard warning switch and walk around the vehicle, checking all indicators.
Tell me how you would check the tyres to ensure that they have sufficient tread depth and that their general condition is safe to use on the road.
Sides of tyres should have no cuts or bulges. There should be a minimum of 1.6mm of tread depth across the central ¾ of the breadth of the tyre and around the entire outer circumference.
Show me how you would check that the brake lights are working on this car.
Operate brake pedal and make use of reflections in windows, garage doors, etc. Alternatively, ask someone to help.
Tell me how you would check the brakes are working before starting a journey.
Brakes should not feel spongy or slack. Brakes should be tested as you set off. Vehicle should not pull to one side.
Tell me where you would find the information for the recommended tyre pressures for this car and how tyre pressures should be checked.
Recommended pressures can be found in the manufacturer's guide. Use a reliable pressure gauge. Check and adjust pressures when tyres are cold. Don't forget to check the spare tyre. Remember to refit valve caps.
Tell me how you would know if there was a problem with your anti-lock braking system.
A warning light will illuminate if there is a fault with the anti lock braking system.
Show me how you switch your headlight from dipped to main beam and explain how you would know the main beam is on whilst inside the car.
Operate headlight switch then main beam switch (with ignition or engine on if necessary). Check main beam warning light is on.
Show me how you would switch on the rear fog light(s) and explain when you would use it/them.
Operate fog light switch (turn on ignition and dipped headlights if necessary). Check warning light is on. Explain use. If visibility is less than 100 metres.
Show me how you would clean the windscreen using the windscreen washer and wipers.
Operate control to wash and wipe windscreen (turn ignition on if necessary).
Tell me me how you make sure your head restraint is correctly adjusted so it provides the best protection in the event of a crash.
The head restraint should be adjusted so the rigid part of the head restraint is at least as high as the eye or top of the ears, and as close to the back of head as possible.
Show me how you would set the demister controls to clear all the windows effectively. This should include the front and rear screens.
Set all relevant controls including: fan, temperature, air direction/source and heated screen to clear windscreen and windows.
Sets with similar terms
Show me tell me 2017
Show Me Tell Me Driving Questions - UK D…
Show Me Tell Me Driving Questions - UK D…
Show Me Tell Me
Other sets by this creator
Sadlier Vocabulary Workshop Level G Unit 6
Sadlier Vocabulary Workshop: Level G: Un…
Sadlier Vocabulary Workshop Level G Unit…