40 terms

General Safety Rules - Part 1& 2

STUDY
PLAY
General: Always wear safety _____________.
glasses
General: Remove ______ clothing and roll up long __________.
loose - sleeves
General: Make all adjustments on the machines with the machine ______________.
stopped
General: Turn off the machine when ___________.
finished
General: Only the _______ of a machine shall turn it on.
operator
General: Compressed air may be dangerous if improperly _______.
used
General: Instructor __________ be in the shop inorder to use the machines.
must
General: Do NOT __________ the operator of a machine.
distract
General: No ___________ or ___________!
yelling - running
General: Advise someone if they are using the machine __________.
improperly
Drill Press: It is necessary to use the chuck key to _______ the chuck.
tighten
Drill Press: _______ the chuck key after tightening the chuck.
remove
Drill Press: Make sure the stock is clamped properly before ________ or boring.
drilling
Grinder: grinding small objects is __________.
dangerous
Grinder: A ____________ is required when using the grinder.
face shield
Grinder: Never grind on the _______ of the grinding wheel.
side
Line Boring Machine: Be sure _________ are not under the clamp when the foot pedal is pressed.
fingers
Line Boring Machine: Fingers should not be in _______ with the drill bit when drilling.
line
Form and Belt Sander: Hold the stock ________ on the table.
firmly
Form and Belt Sander: Know what _______ the belt is turning.
direction
Form and Belt Sander: Take _______ passes.
light
Jointer: Work must be ___ inches long and 1/2 inch thick.
12
Jointer: The maximum depth of cut for face or edge jointing is ____ inch.
1/16
Jointer: Glue in or take out loose _______.
knots
Jointer: Use a push-stick if the work is below the _______.
fence
Procedural Rule: Keep the table ________.
clean
Procedural Rule: What is the ________ on a board?
crown
Procedural Rule: Put the _______ side up.
crown
Surfacer: Work must be ___ inches long and ___ inch thick and a maximum of ___ feet long.
12 - 1/4 - 10
Surfacer: The maximum depth of cut is___inch at a time.
1/16
Surfacer: Glue in or take out loose _____.
knots
Surfacer: Do not look into this machine when ________.
running
Lathe: Set the tool rest ___ inch above or below center and ___ inch away from the project.
1/8 - 1/8
Lathe: Remove the tool rest when ________.
sanding
Lathe: First roughing cuts are made at a _______ speed.
slow
Lathe: Do not stop the lathe with your _______.
hands
Router: Disconnect the ______ from the power circutt when changing bits.
plug
Router: Make sure the _____ is properly installed before turning on the power.
bit
Router: Hold the portable tool ______ but lightly in your hands.
firmly
Router: Never lay the router _______ until the motor has come to a complete stand still.
down