Study sets, textbooks, questions
Upgrade to remove ads
MTA NETWORKING QUIZ~!
Terms in this set (50)
The service that resolves fully qualified domain names (FQDN) to IP addresses is:
A. Windows Internet Name Service (WINS).
B. Domain Name Service (DNS).
C. Internet Service Provider (ISP).
D. Address Resolution Protocol (ARP).
Domain Name Service (DNS).
One purpose of a perimeter network is to:
A. Make resources available to the intranet.
B. Link campus area networks (CANs).
C. Link local area networks (LANs).
D. Make resources available to the Internet.
Make resources available to the Internet.
Which protocol can be used to encrypt packets on the Internet?
A characteristic of the mesh topology is that it:
A. Uses a central hub.
B. Cannot use wired connections.
C. Uses redundant paths.
D. Cannot use wireless connections.
cant use redundant paths
To protect a network when it is connected to the Internet, you should use a:
Security is a concern on wireless networks due to:
A. The radio broadcast access method.
B. Spread spectrum issues.
C. Frequency modulation issues.
D. The potential for cross-talk.
radio broadcast access method
Which two of the following are connectivity options for wide area networks (WANs)? (Choose two.)
A. Token ring
D. Leased line
dial up leased line
A private network that allows members of an organization to exchange data is an:
In which physical network topology is each computer connected to a central point?
If a router cannot determine the next hop for a packet, the router will:
A. Forward the packet to the default route.
B. Send the packet back to the packet's source.
C. Broadcast the packet.
D. Store the packet in the memory buffer.
Forward the packet to the default route.
The function of a router is to:
A. Provide IP subnet masks for hosts.
B. Forward traffic to other networks.
C. Broadcast routing tables to clients.
D. Store tables for name resolution.
forward traffic to other netwrks
To directly connect the Ethernet network interface cards (NICs) of two computers, you should use a:
A. Crossover cable
B. Straight cable
C. Rollover cable
D. Coaxial cable
At what layer in the OSI model are hardware addresses referenced?
C. Data link
You need to divide a network into three subnets.
Which device should you use?
The type of connector used on a 100BaseT Ethernet cable is:
Sets with similar terms
Networking - Chapter 1
Sets found in the same folder
MTA Networking Fundamentals 98-366
MTA Network Fundamentals (#1-10)
MTA Networking Fundamentals. (#11-20)
MTA Network Fundamentals (#21-30)
Other sets by this creator
Day 1 Net II
Day 1 Net II
902 Day 1 Review