Terms in this set (34)
Oral presentations contains acronym and vocabulary prepared for
Expert in the subject area
Select the steps that are in correct order to prepare a technical report
testing and evaluating,
In engineering method stating the Problem correctly is the first step towards the
When engineers are ready to move from Concepts to preliminary designs and possible solutions they often use modeling and __________________ to examine the design
Progression of a project may be displayed as an electronic or paper chart form using horizontal bar graphs to indicate time and task. It is a means of project tracking utilizes.
A gantt chart
One of the final steps to the solution process is to
Always have multiple solution and test each one of them
First requirement for prototype development
Develop a plan
Identifying, defining, selective, implementing and evaluating is part of which process?
Technical writing skills is useful for preparing a report
About the product, service, or application
Creative method of increasing number of engineering design alternatives is
Why is evaluation an important step in the design process?
helps determine whether design is valid
The technician should use a ______ to cut a keyway in a shaft
When using the ammeter, set the range switch at the
Test instruments that displays a waveform is
Reading indicated on the external scale of a vernier caliper
When a micrometer, applied to a telescoping hole gauge, reads 6.488 inches for the diameter of the hole that is to be bored to 6.494 inches, the hole is considered to be:
0.006 inches undersize
Reading a micrometer
A micrometer is a device usually consisting of a calibrated screw that is used for
precise measurements in mechanical engineering
Measurement on the scale below: 64THS ruler
1/64 of an inch
Which of the following is a method of prototype testing?
Prototype testing consists of constructing various test on the prototype that you have chosen to build after deeming it the most optimal.
The best use of chasing die is to
Recut damaged threads
The most accurate way to cut square steel tubing is to use a/an
horizontal band saw
Process uses techniques including constructive solid geometry, implicit surfaces.. Process known as?
Solid modeling/ 3D modeling
A photo detector converts light to an __ signal
Oily and point covered rags should be displaced of
In a metal safety can
When lead acid batteries are charging, they give off
Hydrogen and oxygen
An exposed pipe burst due to freezing. The pipe must be replaced w/ the same material that failed. Best way to protect pipe from failing again
Is by letting water leak which would prevent the water from freezing within the pipe and by having the same temperature in the day and night.
By using a spreadsheet for documenting data, the engineer can produce:
Charts and graphs
Application that requires motor to start & stop 200 times per minute, _____ motor is most suitable
Having things done-out-of-house instead of getting them done in-house is called
The ability to make clear, concise, & precise sketches relates to the engineer's skill with
Which line indicates a hidden edge?
The hidden lines are indicated by the repeated dashed lines which are connected to solid lines as shown in the diagram below
The NEC standard color of ground wire is
The acronym, OEM, refers to
Original equipment manufacturer
Typical gas pressure gauges will read at __ atmospheric pressure
YOU MIGHT ALSO LIKE...
ASCP MLT/MLS Certification Exam (BOC) Preparation
IED FINAL A
ROBOTICS QUARTER 1 ASSESSMENT
OTHER SETS BY THIS CREATOR
FCIQ FINAL REVIEW
FCIQ MIDTERM REVIEW
Quiz for FCSC NYIT
NOCTI ENGINEERING PT4
THIS SET IS OFTEN IN FOLDERS WITH...
NOCTI ENGINEERING PT2
NOCTI ENGINEERING PT3
NOCTI Pre Engineering Exam Study Guide
NOCTI Pre-Engineering Study Guide 2