Upgrade to remove ads
Terms in this set (32)
Which of the following groups are I-MUSE components?
I-MUSE Client, I-MUSE Server, groundbase, and IFC
What is the purpose of Groundbase?
To convert pilot commands into Heimsman code that ScanEagle can understand.
Which pre-defined workspaces are routinely used during ScanEagle UAS Operations?
Standard and Recovery
Which set of plots are crucial to successful UAV operations?
TAS-Alt-Tach and Flight Control
What is the primary purpose of the map in I-MUSE
Which part of the I-MUSE interface displays the event history of aircraft announcements cautions and warnings?
What is the purpose of the Emergency Checklists?
They provide step-by-step instructions for handling specific emergencies
Which f the following best describes I-MUSE checklists?
Normal checklists include embedded tables and panels, buttons, and links
Which I-MUSE component creates the environmental conditions necessary for simulating realistic flight?
Software embedded in IMUSE
When using standalone simulation, you control the aircraft using a combination of the mouse, keyboard,__________, and various panels
A(n) ______________ AP status entry means that the autopilot is OFF and control surfaces and throttle control are under Pilot's Console control.
If AP track is enabled, go to AP shows the waypoint ____________.
Currently being tracked
In a map with DTED, which map color must you avoid flying in unless all other options have been exhausted?
When DTED is available and loaded in the current map pack, I-MUSE uses _____________ colors to indicate elevation safety on maps.
Yellow and red
Which of the following statements describes waypoints and routes?
A waypoint is a set geographical position used for defining a route. a route is a series of interconnected waypoints.
Which image shows a normal route uploaded and acknowledged by the aircraft?
Which control on the VM Desktop Controller is used to create clockwise orbits?
There are five ways to create an orbit. Which way requires you to enter the desired radius, altitude, and direction?
What are ScanEagle's three follow modes?
SPOI, Target, and GCS
When following a target, SPOI, or GCS, open the ___________ panel to fine tune the maneuver.
Which of the following are located on the Aircraft Command and Status Panel?
Which of the following statements describes the data provided on the TAS-Alt-Tach plot?
The TAS-Alt-Tach plot provides actual and trend data for indicated airspeed, AGL altitude, and throttle position.
What determines the parts of the instrument panel the pilot should scan?
What happens to ScanEagle when a higher airspeed is commanded?
Engine power automatically increases to maximum RPM, the aircraft pitches nose down and briefly descends, and airspeed begins to increase.
When scanning the instrument panel, which of the following might show that the throttle is stuck in a high power position?
High RPM with a minimum commanded throttle fraction; aircraft altitude is above commanded altitude and trending upward; a message in the Conditions panel of the System Monitor; a green square around a yellow ScanEagle icon.
The aircraft command and Status Panel allows the pilot to command changes in ____________.
Altitude,airspeed, and turn rates
The TAS-Alt-Tach plot provides actual and trend data for engine performance. The scale for commanded throttle position is displayed on the ____________ side of the plot, and the scale for actual engine RPM is displayed on the ___________ side of plot.
When should check the CHT in the primary indicators?
The auto-pilot is _________- centric
A(n) _____________ AP status entry means that the autopilot is ON.
A(n) _________ AP status entry means that the autopilot is ON and it has been commanded SAFE by the aircraft.
A(n) _________ AP status entry means that the autopilot is ON and it has been commanded SAFE by the pilot or ground station.
THIS SET IS OFTEN IN FOLDERS WITH...
Flight Operations Module Quiz
Scan eagle maintenance
YOU MIGHT ALSO LIKE...
NIQ EXAM 2
Quiz 6: INMARSAT Set-Up
ERJ170 Systems Questions
CH-47F EXAM 1