Upgrade to remove ads
Terms in this set (19)
< 64 bytes
up to 1518 bytes
up to 9000 bytes
which protocols use the Bellman-Ford algorithm?
what does the passive interface do in an EIGRP network?
hello packets will not be sent or received by the router
default timeout for the ping command
what is ospf?
OSPF is a hierarchical, link-state routing protocol that divides an autonomous system into areas
configure login inactivity timeout
exec-timeout <minutes> <seconds>
maximum size of an ISL encapsulated frame
default stratum value for a cisco ntp server
which code from the sh ip route command indicates that the route is the default route?
what does the extended ping command use as the default source?
the IP address of the outbound interface
what is the default target IP address of an extended ping?
there is none
what are the most likely to cause a broadcast storm?
a faulty NIC
a switching loop
default size of an extended ping
to what destination ipv4 address are ripv2 packets sent?
As a packet traverses through the network, when does the SRC IP and DEST IP change and when does the SRC/DEST MAC address.
SRC and DEST IP will only change if NAT is utilized.
SRC/DEST MAC will change if the packet goes through a router. Then, router add the exit interface as the SRC MAC and the next-hop MAC as the DEST MAC
RIPv2 transmits updates how often?
every 30 seconds
YOU MIGHT ALSO LIKE...
Network - Comer 22 & 23
CompTIA Guide to IT Technical Support 9th Ed Chapt…
OTHER SETS BY THIS CREATOR
SEC 160 FE
cct 251 mt
CCT 240 MT
combined SEC 160 MT
OTHER QUIZLET SETS
Chapter 11 key 4 set 1
Theatre appreciation pt 2
BIO 202 learnsmart: the female reproductive system