Upgrade to remove ads
Safety Test (General Shop Safety)
Mr. Goods shop safety test
Terms in this set (38)
Keep all hand tools
clean and in safe working order.
Report any defective tools, machines or other equipment
to the instructor.
Retain all guards and safety devices
except with the specific authorization of the teacher.
Operate a hazardous machine only after
receiving instructions on how to operate the machine safely.
Wear eye protection
whenever there is any danger from flying or falling particles or chips, radiation, glare, or hazardous substances.
Wear approved respirator protection
where harmful dust or fumes exist.
when working around machine tools or rotating equipment.
Wear shop clothes
appropriate to the instructional activity being performed.
Do not carry anything flammable
in or on your clothes.
Remove rings and other jewelry
when working in the shop.
Tie up long hair or anything
that can be pulled into a machine.
Do not participate in
horseplay, practical jokes, or running in the laboratory area.
Report all accidents
to the teacher regardless of the nature or severity.
Turn off the power and waiting for rotating parts to completely stop
before leaving the machine.
Make sure all guards and barriers are
in place and adjusted properly before starting a machine tool.
Keep hands and clothing away
from moving parts.
Recognize the distinctive sounds of
a properly adjusted and smooth-running machine tool.
Develop a respect for
machine tools and understand the purpose.
Use soap and water
frequently as a method of preventing health problems.
Turn on the exhaust fan
whenever any welding is being performed.
Disconnect the power from machine tools
before performing any maintenance.
Extreme care needs to be taken with
any electrical equipment or work regardless of the nature.
Use a solvent/chemical
only after determining its purpose for which it is intended.
Compressed air blown into the skin or body openings
can cause serious injury and even death.
Put tools or other objects
in their proper place when not in use or when you are finished using them.
Protect the cord of a portable hand tool
from oil, water, hot or rough surfaces and chemicals.
Clean metal chips
from a machine or countertop with a brush, not a rag or bare hand.
Wear suitable gloves
when handling sharp, heavy, rough, or hot materials and chemicals.
Use covered metal containers for
oily waste and other flammable rags.
Operate a machine tool
only after being sure that your footing is good.
Keep the shop or lab floor clean of scraps and litter
and immediately wipe up any liquids spilled on the floor.
When operating a machine tool,
give your undivided attention to the task at hand.
Use the correct tools
for any job or operation.
Avoid using wrenches that do not properly fit
nuts, bolts or other objects that they are being use to turn.
Do not block access to
fire extinguishers or exits.
Report any damaged or missing
fire suppression equipment.
Do not leave hot materials
laying around for other to touch.
Before using any powered machine or equipment ________________ for that particular tool.
you must be trained and pass a test
THIS SET IS OFTEN IN FOLDERS WITH...
Welding shop safety
General Shop Safety
Engineering- Final Exam
YOU MIGHT ALSO LIKE...
Lab Safety and Lab Equipment/Procedures
OTHER SETS BY THIS CREATOR
00103 Post test
10. Reading A Tape Measure