Upgrade to remove ads
mod3 from MF
Terms in this set (87)
a ship cannot operate with .... marked fittings secured
what fittings are open and operating regardless of material condition of readiness
the maximum length of time that a fitting may be logged open is ...
decks that extend from port to starboard and forward to aft are referred to as ...
The Bulls eye in shipboard spaces measure .......inch by ....... inch.
12 ; 15
the lettering on a compartment BULL'S EYE is ... inches tall
Small ships have fireplugs placed so that any area on the ship can be reached with ....... feet of a fire hose.
where are sea chests located
On the hull of the ship below the waterline
what fitting must have the commanding officers permission to open
what fittings are secured in order to prevent light from escaping to the outside of the ship
looking at compartment number 4-175-4-E the number 175 identifies...
the forward most frame of the compartment
the frame number designation for a compartment will always be the most ... frame of that compartment
what type of nozzle is at the fireplug
main drainage systems on smaller ships usually...
run fore and aft on the centerline
the drainage system that is found forward and aft of the main machinery spaces is the ... drainage system
what could possible happen if the bilge suction valve is left open when NOT in use
t/f all emergencies on the flight deck are handled by the aviation fuel repair team
what team is found only on air capable ships
crash and salvage
rapid response team is also known as the ... team
at sea fire
the responsibility for fighting fires in engine room/main machinery room belongs to repair ....
the size of the ship determines how many repair lockers are onboard
which repair locker is responsible for the aft portion of the ship
whose responsibility is it to train and evaluate repair party and main space personnel
Special damage control parties and teams are...
At sea fire party, crash and salvage team, and rapid repair response team
who is responsible for organizing and personally directing training of repair five
the only kit that can be ordered by its own national stock number is the ... kit
the sounding tape in the investigator's bag is ... feet in length
navigational draft marks are .... inches in height
investigator's must be familiar with all of the following systems except...
oily water waste system
when reporting the findings of an investigation you should report...
only facts, never opinions
what are the vital principles of an investigation
the isometric damage control diagrams are ... dimensional
Laminated copies of ship's diagrams are used to .......
chart the status and progress of damage control emergencies or drills
how many feet of cable does a X-40 J reel have
Auxiliary circuits are distinguished by a/an ...... prior to the circuit designation.
what things are contained in the damage control diagrams
compartment, tanks, and voids
how many sections are on the rapid plotting message blank
the fire watch inspects the hot work area in order to...
prevent combustible materials from igniting
the fire watch's duties and responsibilities are..
inspect all sides of the bulkhead or deck, ensuring safe distance from combustibles; signal the hot worker in the event of a fire; and know the designation and location of the compartment where he is standing watch
what type of gas is used with the operation of portable exothermic cutting unit (PECU)
the purpose of the PHARS is to provide emergency access or rescue operations that involve...
spreading, lifting, and pulling
when removing an air test cap, if air blows out it indicates possible...
what type of closure uses a single handwheel to operate all dogs simultaneously
quick acting watertight scuttle
the time required to complete all maintenance listed on the EGL should NOT exceed ... hours
t/f the PMS master file contains maintenance requirements information that pertains to all equipment of a command
what reference provides information about the chemical and physical characteristics of a HAZMAT
material safety data sheet
•The type of wrench that requires calibration for accuracy is the ____ wrench.
what is the proper sequence to align an installed eductor for operation
discharge valve, fire main actuation valve, and bilge suction valve
the safety disk on the CO2 cylinder will rupture at ... psi
the CO2 cylinder will be pressurized to ... psi at ... degrees F
who is directed by the on scene leader and is in charge of the attack team
t/f there is a minimum of four personnel assigned to the rapid response team
the portable AFFF extinguisher cylinder must be grounded while being discharged
AFFF extinguisher is intended for use on class ... fires
who overhauls a class charlie fire
extinguishing agents and methods for magnesium fires
dry sand, powered graphite, and calcium carbonate
what portable extinguisher is used in conjunction with AFFF to fight a class bravo fire
27 lb PKP entinguisher
what is the additional primary duty of the plugmans during flight deck firefighting
communication with the AFFF station
what color jerseys will the flight deck fire party wear
a SCBA cylinder has a service life of ... years before it has to be reserviced
what must you do with the ram fan after each use
flush with fresh water
what is the power source for the box fan
the three standard navy fire hoses sizes are
1 1/2, 2 1/2, 4 inches
the two standard rated capacities of the 1 1/2 in the vari nozzle are ... and ... gpm
on a fire hose station, the hose must be stored ... inches off the deck
pumps are protected by debris in the concentrate by a ...
purpose of the APC cylinder
controls and stores the APC solution and propellant
three APC nozzle types
appliance, duct, plenum. NOT in line
The Halon 1301 time delay bypass/override valve is used for .......
immediate discharge capability
the CO2 actuator cylinder for the halon 1301 system contains ... pounds of CO2
halon 1301 is ineffective for class ... fires
A space flooded with Halon 1301 must be ventilated at high speed for at least 15 minutes and ....... before entering without a OBA/SCBA.
gas free tested
the halon 1301 flooding system cylinders are equipped with a safety disk which ruptures at ... psi
what is one safety consideration with the use of halon
it becomes toxic about 900 F
t/f CO2 flooding system time delay is set at 60 seconds
t/f after activation of the carbon dioxide flooding system at least 15 mins isrequired before reentry
the time required to complete all maintenance listed on the EGL should not exceed.... hours
who is assigned by the on scene leader, and is in charge of the attack team
Portable AFFF Extinguisher is intended primarily for use on class ....... fires.
what is the recommended extinguishing agent for magnesium fires
who establishes and maintains an ongoing FOD prevention program
helicopter control officer/ flight deck officer
What color jersey does a plane captain wear?
during normal operation, the only moving part of the hytrol valve is the...
The Halon cylinders are super pressurized with ......
the time delay assemblies on the halon 1301 provides time ...
for ventilation shut down
personnel should not be subjected to halon concentration over 7% for more than ... mins
the toxic vapor is produced when halon is exposed to temperatures of 900 F or above
YOU MIGHT ALSO LIKE...
BECC MOD 3
BECC MOD 3
NYC FSD test
OTHER SETS BY THIS CREATOR
MOD 3 from notes