Upgrade to remove ads
Chapter 16 Roof Design
Terms in this set (26)
Easy to build, sheds water well and provides for ventilation.
Gable Roof e more suited to
A roof type more suited to houses in warm, dry climates than in cold, wet climates.
Extend from the ridge of the roof to the plate or beyond.
The width of a narrow box cornice is normally between
6" and 12"
In a _________, cornice, the rafter does not project beyond the wall.
Which of the following is a feature of lightweight wood roof trusses?
Generally 2x4 lumber is used in lightweight wood roof trusses.
The recommended total area of ventilator openings in the attic space should be a minimum of 1/300th of the ceiling area. How much ventilator area should be planned for a house with a ceiling area of 1800 square feet.
At least 6 square feet.
Flashing should be used.
Where any feature pierce the roof, where a roof attaches to a second floor wall and next to the chimney.
The most popular type of roof material for residence.
When the roof pitch is 12:12 and the span is 24', how high is the roof ridge above the top plate.
The least expensive type of roof to construct is the,______ roof.
The ________roof type is used a great deal on barns.
It is a good practice to use of the standard roof, _____ a slopes when designing roof.
The cornice forms a two sides of a ____________ roof.
In the _____________ cornices, rafter ends are exposed and generally tapered or curved to eliminate bulk.
The soffits boards is nailed to the underside of the rafter in a _____________box cornice.
Wide box cornices without lookouts have,_______ soffits.
The span of a gable roof past the end wall of the dwelling is the __________ or gable end.
The W-type truss, the _______ truss, and the scissors truss are generally used in residential construction.
Two results of a well ventilated attic are less ______ buildup to cause damage to the underside of the sheeting and a cooler house in the summer.
The width of the valley flashing is dependent upon the slope of the roof. A roof slope of 5:12 requires flashing at least wide.
Gutters are commonly made from galvanized sheet metal, aluminum, and _______
Plywood sheathing should be placed with the perpendicular to the rafters.
A moisture barrier is required between the sheating and the shingles. Generally, building paper of 15 pound, saturated__________, provides this barrier.
___________, is required where any feature, such as a chimney or section of a wall, pierces the roof.
The area of the roof that includes overhang forming a connection between the roof and side walls is called the _________________
THIS SET IS OFTEN IN FOLDERS WITH...
Elevations - Chapter 22
Chapter 19 Architecture
Architecture Chapter 19 Vocab
Drafting Chapter 8
YOU MIGHT ALSO LIKE...
Chapter 16 Roof Design
OTHER SETS BY THIS CREATOR
Chapter 2, 6, 15 and 20
Elevations Chapter 22