Upgrade to remove ads
Only $35.99/year

FINAL STUDY GUIDE

Terms in this set (118)

AIRCRAFT DRAWINGS
...
What type of line is normally used in a drawing or blueprint that indicates invisible edges or contours?
Medium-weight short dashes, evenly spaced
In the isometric view of a typical aileron balance weight identify the view indicated by the arrow
3
A specific measured distance from the datum or some other point identified by the manufacturer, to a point in or on the aircraft is called a
station number.
A hidden line used to show an edge that is is not visible
...
8113 What are the proper procedural steps for sketching repairs and alterations?
3,1,4,2 " Block in the space " Add details to basic blocks " Darken the lines " Add dimensions and any other information
What should be the first step of the procedure in sketching an aircraft wing skin repair
Block in the views
A simple way to find the center of a circle on a sketch or drawing, or a circular piece of material is to
draw two non-parallel chord lines across the circle and then a corresponding perpendicular bisector line across each chord line.
What is the class of working drawing that is the description/depiction of a single part?
Detail drawing
Sketches are usually made easier by the use of
graph paper
Finished marks are used to indicate that a surface must be machine finished
...
Which material section line indicates cast iron
Zebra lines (3)
The measure showing the ideal or perfect sizes of parts on drawings are called
Dimensions
The diameter of the hole in the finished object is
1/2 inch
The vertical distance between the top of the plan and the plate and the bottom of the lowest 15/64 inch hole is
2.367 " Covert fractions and add what's given "
Other sets by this creator