Your company has installed a guest wireless network in the break room. According to company policy, employees may only connect to the network and use it during their lunch break. Which of the following policies should you have each employee sign to show they understand and accept the use conditions for this guest network?
Click the card to flip 👆
1 / 355
Terms in this set (355)
Your company has installed a guest wireless network in the break room. According to company policy, employees may only connect to the network and use it during their lunch break. Which of the following policies should you have each employee sign to show they understand and accept the use conditions for this guest network?
A Start of Authority (SOA) resource record indicates which Domain Name Server (DNS) is the best source of information for the specified domain. An AAAA record associates your domain name with an IPv6 address. An A record associates your domain name with an IPv4 address. An MX record is used for outgoing (SMTP) and incoming (POP3/IMAP) traffic.
A network technician has just installed a new point-to-point 200-meter single-mode fiber link between two local routers within the Dion Training offices. The fiber has been connected to each router, but the interface fails to come up. The network technician has double-checked the interface configuration on both routers, both SFPs have been hard looped to confirm they are functioning, connectors on both ends of the links have been cleaned, and there is sufficient power. What is the MOST likely cause of the problem?
You have just installed a new switch in your company's network closet. The switch connects to your router using an SFP port on both the router and switch. Unfortunately, you only had a long cable available to make the connection, so after running the cable from the rack containing the switch to the other rack containing the router, you decide to coil up the excessive cable and use a zip tie to hold the coil to the side of the rack. You head back to your office, log into the switch over SSH, and check the log file. You notice that several messages indicate that the signal strength on the transmit portion of the SFP is registering as too weak. What is the BEST explanation for the cause of this error?