Section 5.2 Floppy Drives
Terms in this set (4)
A used has called to complain that he can't save a file to a floppy diskette in his floppy drive. What should you do first (Select Two)
a. Verify that the diskette has been inserted and properly formatted.
b. Run the CMOS setup program and verify that the correct type of floppy drive has been configured.
c. Replace the floppy diskette drive with a known-good unit.
d. Make sure the write-protection tab on the diskette isn't set.
e. Verify that the latest BIOS updates have been installed.
Verify that the diskette has been inserted and properly formatted.
Make sure the write-protection tab on the diskette isn't set.
You just installed a new floppy disk drive. After booting the computer, the drive light stays lit. What is the most likely problem?
a. You forgot to load the software driver for the floppy disk drive.
b. You installed the drive before the twist in the ribbon cable.
c. You used the wrong power cord to connect the drive.
d. The floppy disk drive is defective.
e. The ribbon cable is connected backwards.
The ribbon cable is connected backwards.
You are installing a floppy drive. You want the floppy drive to be the A: drive. How do you do this?
a. Install the drive before the twist in the ribbon cable.
b. Edit the operating system settings.
c. Install the drive after the twist in the ribbon cable.
d. Edit the CMOS settings.
Install the drive after the twist in the ribbon cable.
What kind of power connector does a floppy drive use?
a. ATX power connector
b. Mini-molex connector
c. AT power connector
d. Molex power connector
Mini-molex power connector
YOU MIGHT ALSO LIKE...
Test Preparation TOEIC, SAT, TOEFL
TestOut Flashcards - 13.2 Storage
5.6.10 Storage Troubleshooting Practice Questions
OTHER SETS BY THIS CREATOR
Medical Coding & Billing ICD-10 Final
Medical Coding & Billing ICD-9 Final
Section 12.10 Proxy Servers
THIS SET IS OFTEN IN FOLDERS WITH...
Section 5.1 Storage Devices
Section 5.3 Parallel ATA (IDE)
Section 5.4 Serial ATA
Section 5.7 File System